<

快盈v3

SZ CnAuto automation equipment Co., Ltd.

快盈v3Specializing in the production of automatic\precision\high speed dispenser manufacturers

Hot Tel:

18929475867

Contact

TEL:

18929475867

快盈v3

Email:jerry@prcrobot.net

QQ:a href="http://wpa.qq.com/msgrd?v=3&uin=88965272&site=qq&menu=yes":

快盈v3ADD:东莞市塘厦镇石潭浦大迳路62号

Three axis circular arc dispensing technology of jet equipme

作者:涂胶机   日期:2020-03-20 14:52   浏览:

  Circular arc dispensing technology is basically not applied in spray dispensing equipment, because it requires three or more mechanical shafts to be realized, while many spray equipment take two shafts as the core shaft number, so there is no way to realize circular arc dispensing technology, in fact, it has a certain relationship with the use of glue. The viscosity of glue used in spray dispensing machine is basically low viscosity glue.
 
喷射式三轴点胶机   
  The spray type three-axis dispenser adds a shaft to the mechanical shaft. There is also a risk for stability. The mechanical shaft may be unstable in motion. Adding a shaft requires overcoming these problems before it can be used. The dispensing problem can be avoided. According to the current requirements of glue uniformity, no deviation can occur. A little bit will affect the dispensing effect. According to the above situation It determines the application of dispensing equipment. The application of syringe dispensing machine is to meet the requirements of glue quantity, product, accuracy, etc., and any problems can not be avoided.
 
  Spray type three-axis dispenser realizes circular arc dispensing technology, which needs to be equipped with visual dispensing system to accurately control dispensing accuracy. Because it is difficult to reach high accuracy standard by using spray dispensing and manual debugging machine for glue quantity control, so in order to solve the problem of glue uniformity, our company adopts CCD visual dispensing system to realize stable dispensing control, thus becoming simpler and more dispensing The effect is better than that of the syringe dispenser.
点胶针筒
  Circular arc dispensing technology is a technology that can be realized by the three-axis syringe dispenser every day. It can not only solve the dispensing requirements of products, but also solve the problem of glue uniformity. It can solve the special dispensing requirements in many aspects by using the syringe dispensing function. Now the machine production technology is more and more developed, the product requirements are higher and higher, a little bit of small defects can not pass, and the accuracy requirements are very high. Our company Also gradually take the high-end line, the production of spray type three-axis dispenser.
 
螺杆点胶阀   
  The piston pressure barrel is an accessory produced by our company. It is used to store glue. The production speed of the jet type three-axis dispenser is very fast. About 5kg glue is used every day. If there is no piston pressure barrel, the needle barrel needs to be replaced frequently. The production speed is delayed by at least 20%. The way of use is very important. Then a large amount of glue is needed. It is not right to use the needle barrel for production. It is the most appropriate production to develop strengths and avoid weaknesses Methods: the application of visual spraying in circular arc dispensing technology is a three-axis dispensing machine.